Resequence all Nodes

The Resequence all nodes command will allow you to specify a new node number for all nodes in the FHC project file. You will need to specify the source node number and the node increment number. You can access the resequence all node command from the menu Draw->Resequence all nodes.

The Draw->Resequence all nodes command can be selected from the draw menu or use the the short cut key [Ctrl+R]

The last Start Node number and the Node increment number will be saved between sessions.

Start node number

Enter the start node number you wish to use, this can be a number between 1 and 9000 however its always best to have a low number so you have room for the network to grow.

Node increment

Enter the node increment number. You can use any number but a lower number will save you from having to the use the command to often but have some room encase you wish to use the Break command!

OK Button

Press the OK button and FHC will renumber all the nodes in the FHC project.

Cancel Button

The Cancel button will close the Resequence all Node dialogue box

FHC - Reference & Tutorial | Version 2.4

Navigation: Reference for FHC \| Draw menu \| Resequence all Nodes
Resequence all Nodes